1. Cleanse and prime the natural lashes thoroughly — a wrapped base shows residue faster than a bonded one.
2. Map the set and decide where the wet finish will run, whether that is the full set or a contrast section.
3. Isolate a single natural lash and hold it clear of its neighbours before you pick up the fan.
4. Pick the fan up at the root and take a controlled amount of adhesive, keeping it off the fibre tips.
5. Wrap the root around the isolated lash rather than pressing it on top, then hold until the bond takes.
6. Check the alignment with the eye open before the adhesive sets, and comb through once cured.

• Placing the fan on top of the lash — treating it like a bonded base loses the wrap and the sleek finish with it. Roll the root around the natural lash instead.
• Over-applying adhesive — excess glue fills the root and stops it wrapping, which reads as a bulky base. Use a controlled amount and re-dot often.
• Skipping the cleanse — oil on the lash line stops the wrapped root gripping evenly. Cleanse and dry fully before isolating.
• Using one curl across every eye shape — the wet effect exaggerates a curl mismatch because the lash line is so uniform. Match curl to growth angle per client.
• Selling it as a low-maintenance set — the sleek finish shows grow-out sooner than a textured set. Book infills earlier and set that expectation up front.

• Product type: Wet-look promade fans with a non-adhesive root
• Fan structure: 5D fan
• Diameter: 0.07
• Curls: C, CC, D
• Fibre: High-quality korean pbt
• Base: A non-adhesive root that wraps the natural lash
• Quantity: 1,440 fans per tray
• Sourcing: Vegan, cruelty-free
• Use: Professional lash extension application only

Adhesive is purchased separately. Patch test new clients for adhesive sensitivity before a full set.

My wet sets lose the glossy look after a week — is that the fan or the aftercare?

Most often aftercare: oil-based cleansers and heavy eye creams dull the fibre and loosen a wrapped root faster than a bonded one. Send clients home with a lash-safe foam cleanser and a clear instruction to keep oil away from the eye area.

How do I stop the wrapped roots looking uneven across the lash line?

Wrap in the same direction on every placement and check with the eye open before the bond sets. An inconsistent wrap direction is what makes a wet set look ragged rather than sleek, and it is easy to correct while the adhesive is still adjustable.

Is 0.07 too heavy for a client who normally wears classic extensions?

It depends on the natural lash rather than the diameter alone — a healthy medium lash usually carries it comfortably, while a fine or previously stressed lash does not. On those clients drop to a finer fibre at a higher count for the same visual density.

Can I mix this tray with other promade fans in the same set?

Yes, and it is a useful way to control weight and cost — but keep the two in separate zones rather than alternating lash by lash, because different base sizes show as uneven texture. Keep the curl consistent between the layers so they do not fight each other.

How should I adjust my adhesive when the room gets humid?

Humidity speeds the cure, so the base can set before the fan is fully seated, which reads as a weak bond a week later. Move to a slower adhesive with a longer working time rather than speeding up placement, and refresh the dot more often as it skins over.