1. Cleanse and prime, then assess natural lash strength - the long spikes concentrate real leverage.
2. Tape and map the eye, planning the spike rhythm and confirming curl against natural growth angle.
3. Isolate a single natural lash, reserving the strongest lashes for spike positions.
4. Dispense a generous glue dot - this specification puts the highest torque of the wispy range on the base.
5. Dip the base only, keeping the fan and spike clear.
6. Place, orienting the spike into your rhythm and checking it is not crossing a neighbour.
7. Orient fans flatter between spike points so the height contrast is legible.
8. Comb through, verify no crossing spikes, and cure fully.

• Mapping to the spike length - with a three-size differential this overstates the set dramatically. Map to the fan body.
• Placing long spikes on fine lashes - the leverage is the highest in the wispy range and those placements shed first.
• Curl mismatch - a long spike on the wrong curl will cross into its neighbours and disrupt the whole zone.
• Continuous spiking - the larger differential makes over-spiking look chaotic rather than merely busy.
• Standard glue dosing - increase the dot specifically for the leverage these spikes apply.

RETENTION TIPS FOR LONG-SPIKE WISPY SETS

A longer spike differential means every spiked placement carries more torque, so retention management is specific to this specification.

• Increase the glue dot on spike placements and confirm full base contact before releasing - partial contact fails here first.
• Reserve spike positions for the client's strongest natural lashes and place plain fan orientations on the finer ones.
• Keep the fan body length conservative; a long body plus a long spike compounds the leverage.
• Book infills at 2-3 weeks, since the spike rhythm degrades visibly before the coverage does.
• Advise the client against rubbing or sleeping face-down; long spikes catch and shear more readily than a flat fan.

Materials: PBT pro-silk fibre with a light cosmetic bonding agent at the base. Vegan, latex-free and cruelty-free. Patch test new clients for adhesive sensitivity.

Does a three-size spike differential look too extreme on ordinary clients?

It reads as graphic rather than subtle, which is the point, but it does not suit every eye - on small eyes and hooded lids the long spikes can dominate. Reserve the full differential for the outer third on those clients and let the fan body carry the centre.

How do I stop long spikes crossing into neighbouring lashes?

Curl matching and clean isolation, in that order. A spike on a curl that fights the natural growth angle rotates as it settles, and a partially caught neighbour pulls it off-axis. Both are visible immediately if you check before releasing rather than at the end of the set.

Is this specification safe on average natural lashes?

Nine fibres at 0.05 is a moderate weight, but the long spike extends the lever arm significantly, so treat the safe load as lower than the fibre count suggests. On average lashes, place spikes selectively and use flatter fan orientation elsewhere.

Why does my spike rhythm look uneven at infill even though retention was good?

Because spikes rotate as the natural lash grows, so a rhythm that was correct three weeks ago no longer reads. Assess the whole spike pattern at each infill and replace rotated spikes as well as missing ones.

Can I use these on a hybrid map?

You can, but the dense fan body and long spike together tend to overwhelm classic lashes beside them, so the hybrid reads as two unrelated products. A lighter wispy specification integrates into hybrid work far better.