1. Complete the lash lift or brow lamination according to the system's professional processing instructions.
2. Remove any remaining processing-product residue as directed before applying the finishing serum.
3. Pump a small, pea-sized amount onto a clean lash brush, then gently brush the serum over the treated lash or brow hairs.
4. Allow the serum to remain on the hairs for 1–2 minutes.
5. Do not rinse. Gently brush the lashes or brows into the desired finished position and leave the serum on as the final conditioning step.

• Applying too much serum → Excess product can leave the hairs looking overly wet or weighed down. Apply only a thin, even coating and distribute it carefully with a microbrush.
• Applying before processing is complete → A nourishing serum should not interfere with the lifting or fixing stages. Complete the chemical process first.
• Rinsing after application → The formula is designed as a no-rinse finishing treatment. Leave it on after the recommended 2–4 minute period.
• Getting product into the eyes → Working too close to the waterline increases the risk of contact. Apply precisely to the hairs and maintain appropriate eye-area control.
• Using contaminated applicators → Reusing unclean tools can compromise hygiene. Always dispense and apply with clean professional applicators.

Ingredients: Aqua, Allantoin, Hydroxyethyl Cellulose, Acrylates/C10-30 Alkyl Acrylate Crosspolymer, Arginine, Panthenol, Hydroxyacetophenone, 1,2-Hexanediol, Gold, Methylpropanediol, Glycerin, Myristoyl Pentapeptide-4.

Professional-use cautions: Use gloves during application and avoid direct contact with the eyes and surrounding skin. If accidental eye contact occurs, rinse thoroughly and seek medical advice if irritation persists. Keep the product away from excessive heat and direct sunlight, and store it out of reach of children. Follow the recommended application amount rather than saturating the treated hairs.

Can I use the 24K Gold Serum on lashes or brows that feel dry after processing?

Yes, it can be used as the conditioning finish after a correctly completed lift or lamination service. However, it cannot reverse structural damage caused by significant overprocessing, so visibly compromised hairs should not simply be reprocessed and covered with serum.

Why do the brows sometimes look too glossy or separated after I apply the serum?

This usually indicates that too much product has been applied. Use a smaller amount and brush it evenly through the hairs so the finish looks conditioned and polished rather than saturated.

Can I apply the serum after brow tinting during the same appointment?

Potentially, but the order should follow the instructions of the specific tint and lamination systems being used. Complete any steps that require completely clean or product-free hairs before applying the serum as your finishing treatment.

Can I layer another brow or lash conditioning product over this serum immediately?

Usually there is little benefit to heavily layering multiple finishing formulas during the same appointment, and doing so can make the hairs feel coated. Use one appropriate finishing treatment unless the product manufacturers specifically confirm that the formulas are designed to be layered.

Can I use this serum before applying lash extensions to the same lashes?

Avoid using an oily, conditioning, or leave-on finishing product immediately before extension attachment unless compatibility with the adhesive system has been confirmed. Residue on the natural lash can interfere with the clean bonding surface required for consistent adhesive attachment.